Sector antennas are designed to provide segmented microwave coverage over a selected (sector) area; sector antennas deliver a wider beam width than point-to-point parabolic antennas. Wi-Fi Sector antennas are typically used for wireless connections between LAN base stations, wireless Internet, subscriber networks, PCS and other point-to-multi point communications. This type of setup is usually found in RV Parks, Marinas, or other outdoor areas, where the main antenna is broadcasting a signal from a building that is located at one end of the park.  A sector antenna should be used to force the signal in your desired direction, and avoid sending the Wi-Fi signal to unwanted areas.  Antenna configurations can consist of flat panel micro strip and slot radiating designs, as well as traditional parabolic configurations.

 

The added signal strength and sensibility that comes with this Outdoor 17dbi Sector Antenna will make your Wireless Installation easier and more secure.  Mount this 2.4GHz Sector Antenna on top of your building, Marina, RV-Park or Hotel, and tilt it towards the desired coverage area for a great signal, and excellent Wireless Coverage.  This antenna comes with a mounting system that adjusts from 0 to 20 degrees down-tilt.

 

Mounting Hardware is included, as well as basic Technical Support to get you started on your Wireless Installation.  This 17dbi Sector Antenna works great in Point to Multipoint solutions as well.  Simply Mount the Outdoor Sector Antenna in pairs to create a 180° of Coverage; in a set of Three, to create 270° of Coverage, or in a set of Four, to cover an entire 360° area.  You can also use the 17dbi Sector Antenna as a stand-alone Antenna for the desired 90° of coverage. 

 

If your Internet Location is located in the corner of your location, and your desired coverage area is not 360 degrees, a sector antenna is a better solution as you will not waste the Wireless Coverage in areas you do not need it.

 

For the best results, this Outdoor 2.4GHz Sector Antenna should be used in situations where you have Line-of-Sight to the client locations.  Please contact us if you have questions about your setup, or need higher gain, outdoor Antennas. 

 

Range estimates for RV Parks, Campgrounds, Marinas, etc., will be considerably less, as the distance will depend on receive sensitivity of Access Point, and quality of laptop.  The more obstructions in your application, the shorter the range.  To compensate for this loss, it is recommended to add additional Access Points throughout the area, (repeaters).  This will increase the signal strength to end users.

 

Please note:  Typical Wireless Range will be dependent on the following:   Transmit Power of your Access Point or Wi Fi Router Outdoor Obstructions (trees, lakes, buildings, RV's, hills, etc.) Type of building material (metal, aluminum, wood, sheetrock) Mounting position of antenna dbi Gain of the outdoor antenna Length of coax cable connected to the antenna Client device receive sensitivity, and transmit power The stronger the transmit power of the access point, the better your wireless signal will carry, and provide a more enjoyable Internet surfing experience for your customers.  The Transmit Power on typical Linksys, Dlink and Belkin Wireless Access Points/Routers,  is usually in the 15dbm range, or 32mW Transmit Power.  This means that connecting a high gain antenna will help your range, but will not provide the increased distance and signal strength that say a 200mW, or even 500mW Wi Fi Access Point will provide.  To get the best range from your outdoor wi fi antenna, please ask us about upgrading your Linksys or D-Link Access wireless access point.

 

 

Electrical Specifications   Frequency 2400-2500 MHz Gain 17 dBi Horizontal Beam Width 90 degrees Vertical Beam Width +/- 6.5° Impedance 50 Ohm Max. Input Power 250 Watts VSWR < 1.3:1 avg. Connector N Female Lightning Protection Direct Ground Mechanical Specifications Weight 10 lbs. ( 4.54 Kg) Dimensions 39 x 6 x 2.5 inches Radome Material UV-Inhibited Polymer Operating Temperature -40° C to to 85° C (-40° F to 185° F) Mounting 2 inch (5 cm) O.D. max. Polarization Vertical Down-tilt (mech) 0 to 20 degrees (adjustable) Include Mounting Brackets Yes RoHS Compliant Yes