Sector antennas are designed to provide segmented microwave coverage over a selected (sector) area; sector antennas deliver a wider beam width than point-to-point parabolic antennas. Wi-Fi Sector antennas are typically used for wireless connections between LAN base stations, wireless Internet, subscriber networks, PCS and other point-to-multi point communications. This type of setup is usually found in RV Parks, Marinas, or other outdoor areas, where the main antenna is broadcasting a signal from a building that is located at one end of the park.  A sector antenna should be used to force the signal in your desired direction, and avoid sending the Wi-Fi signal to unwanted areas.  Antenna configurations can consist of flat panel micro strip and slot radiating designs, as well as traditional parabolic configurations.

 

The added signal strength and sensibility that comes with this Outdoor 14dBi Sector Antenna will make your Wireless Installation easier and more secure.  Mount this 2.4GHz Sector Wi-Fi Antenna on top of your building, Marina, RV-Park or Hotel, and tilt it towards the desired coverage area for a great signal, and excellent Wireless Coverage.

 

Mounting Hardware is included as well as basic Technical Support to get you started on your Wireless Installation.  This 14dBi Sector Wi-Fi Antenna works great in Point to Multipoint solutions as well.  Simply Mount the Outdoor Sector Antenna in pairs to create a 240° of Coverage, or in a set of Three, to create 360° of Coverage.  You can also use the 14dBi Sector Wi-Fi Antenna as a single, stand-alone Antenna for the desired 120° of coverage. 

 

Advantages of using Sector Antennas vs. Omni Antenna:

• More Clients: By using 3 sectors with 3 Access Points, you can triple the number of clients in a given area. This increases range, reduces latency, and speeds up network efficiency.

• Better signal levels:  Sector antennas usually have more gain than Omni's. This results in fewer retries and less packets lost.   By focusing the signal in the desired area, you increase signal strength.

• Eliminate interference: Because a sector antenna is directional and usually has good front-to-back (F/B) ratio, it can reduce or eliminate interference from sources that are behind the sector antenna.  You also eliminate overshooting your clients, which will happen when mounting an Omni antenna too high above the client.

• Channel Re-Use - Because the sector antenna can be down tilted, mechanically 3, 6, or 8 degrees, the signals are not thrown out to the horizon. This allows that same channel to be re-used several miles away at a different cell site, without overlapping.  You can also have 3 separate antennas configured to use 3 separate channels, 1, 6 and 11 simultaneously.

For the best results, this Outdoor 2.4GHz Sector Antenna should be used in situations where you have Line-of-Sight to the client locations.  Please contact us if you have questions about your setup, or need higher gain, outdoor Wi Fi Antennas.

 

Range estimates for RV Parks, Campgrounds, Marinas, etc., will be considerably less, as the distance will depend on receive sensitivity of Access Point, and quality of laptop.  The more obstructions in your application, the shorter the range.  To compensate for this loss, it is recommended to add additional Access Points throughout the area, (repeaters).  This will increase the signal strength to end users.

 

Please note:  Typical Wireless Range will be dependent on the following:   Transmit Power of your Access Point or Wi Fi Router Outdoor Obstructions (trees, lakes, buildings, RV's, hills, etc.) Type of building material (metal, aluminum, wood, sheetrock) Mounting position of antenna dBi Gain of the outdoor antenna Length of coax cable connected to the antenna Client device receive sensitivity, and transmit power The stronger the transmit power of the access point, the better your wireless signal will carry, and provide a more enjoyable Internet surfing experience for your customers.  The Transmit Power on typical Linksys, Dlink and Belkin Wireless Access Points/Routers,  is usually in the 15dbm range, or 32mW Transmit Power.  This means that connecting a high gain antenna will help your range, but will not provide the increased distance and signal strength that say a 200mW, or even 500mW Access Point will provide.  To get the best range from your outdoor antenna, please ask us about upgrading your Linksys or D-Link Access point.

 

 

Electrical Specifications Frequency 2400 - 2500 MHz Gain 14 dBi Polarization Vertical Horizontal Beam Width 120° Vertical Beam Width 15° Impedance 50 Ohm VSWR < 1.5:1 avg. Front to Back Ratio > 21 dB Max. Input Power 300 Watts Lightning Protection DC Ground Connector N-Female connector Mechanical Specifications Weight 4.4 lbs. Dimensions 20 x 7 x 3.5 inch Radome Material UV-inhibited Plastic Mounting 2 inch (50 mm) dia. mast max. Operating Temperature -40° F to 185° F Rated Wind >130 MPH (210 Km/h) RoHS Compliant Yes