No products in the cart.

802.11N, 5.7 – 5.8GHz Point to Point Wireless Bridge, 12dBi Integrated Panel Antennas, 29dBm TX/RX Power, WPA/WPA2 security, POE/PS included, – Pre-Configured – 1/3 Mile Complete Link


Part #: GNS-1161N

160Mbps, Ethernet Bridge, 12dBi Antennas – 1/3 Mile – Complete Link

Availability: Out of Stock


Note:  A faster option is now available.  Part# GNS-1163AC wireless bridge offers 500Mbps.

GNS-1161N, Complete Point to Point Wireless Bridge kit allows you to connect any 2 locations up to 1/3 miles apart.  Unobstructed Line of sight is recommended.

Whats included in this point to point wireless bridge kit (complete link):

2x Outdoor Radio w/ Integrated 12dBi Patch Antenna
2x Power over Ethernet Injector (PoE)
2x Power Supply
2x 25ft. cat5e Ethernet Cable
2x Pole Mount Hardware for 1-1.5″ OD mast

Bridge antennas are pre-configured for “out of the box” installation and operation. External Signal LED’s will assist with alignment and troubleshooting procedures. Maximum cat5e cable to be used on each end is 250ft. (Shielded cat5e is recommended).  1 year warranty includes technical support.

This complete link ships pre-configured for “out of the box” installation. No configuration is required. Web based management allows for adjustment of TX/RX power, Security type, signal strength/signal noise reading, and real time throughput estimates. POE, PS, and pole mount hardware is included in the kit. Any 1-1.5″ diameter mast/pole, will allow you to mount the antennas. If you require additional mounting hardware, please let us know.


Basic Description:
This 802.11N Point to Point Wireless Bridge includes a pair of outdoor access points, that have an integrated 12dBi directional patch antenna built into the enclosure. This means that only a single, small enclosure is required at each location. Once the AP’s are installed at each location, the Wireless Bridge operates as a transparent bridge, and will pass all network traffic between your two locations. The Wireless Bridge operates similar to an invisible Ethernet cable connecting your two locations. Each antenna has a beam width of about 10°, so aligning the antennas is easy. Furthermore, you will have the ability to view real time signal strength, link quality, and noise level, using the web based configuration. Each AP has a static IP address, used strictly for web based configuration, and troubleshooting.

Connection to Network:
To connect the access point to your network at each location, a single Cat5 Ethernet cable is used. A 25ft. cable is included for each location. (If you need more cable, a maximum length of up to 200ft. can be used) The Cat5 Ethernet cable connects directly from the outdoor access point using a weatherproof grommet, to an indoor POE (Power-over-Ethernet) injector. The POE injector plugs into a standard AC outlet for power, and another Cat5 Ethernet cable connects from the POE injector to your network (Router/PC/Switch etc.)

At the MAIN location, you will typically connect to an open LAN port on the back of your existing router, or switch. At the REMOTE location, you can connect either directly to a PC if you only have a single computer, or you can connect to an indoor wired/wireless router. This will allow you to run multiple computers over the wireless bridge. See Diagram below.

Additional information

Weight 20.0000 lbs

Out of Stock


There are no reviews yet

Be the first to review “802.11N, 5.7 – 5.8GHz Point to Point Wireless Bridge, 12dBi Integrated Panel Antennas, 29dBm TX/RX Power, WPA/WPA2 security, POE/PS included, – Pre-Configured – 1/3 Mile Complete Link”

You may also like…